Materials Engineers

 
Home | Ceramic engineering | Tribology engineering | Rubber engineering | Polymer engineering | Paint/coatings engineering | Metal and Metallurgy engineeri | Material engineering other top | Magnetic engineering
  Position:Home>Material engineering other top>Article Content
Penetrating Oils
Source:Internet Author:Unknow Pubdate:2010-06-03  
swall (Materials) 8 May 10 10:49
Anyone know the science (if there is any) behind how penetrating oils are supposed to work? I can understand the penetrating part, since we have products like dye penetrant and wicking Loctite. But, how does a rusted up joint come loose after the stuff gets in? I am thinking that for anything to happen, there would have to be an acid component, chelate, or something to dissolve the rust.

micalbrch (Mechanical) 8 May 10 12:00
No, there is no acid or something in it. The rust (the oxidated metal) is not dissolved or something like that. Penetrating oils displace the water/moisture out of the rusted up connection. That in combination with their penetrating capability is the science behind. It is more physics than chemistry.

unclesyd (Materials) 8 May 10 15:28 字串2
I've seen several explanations on why they work, sometimes. It has been my observation they do in fact work especially where the initial joint didn't have extremely close tolerances.  

Here are some tricks I've observed in using the penetrating oils. The better one is to slightly warm the joint prior to application.  Another one is the tap the nut or stud while applying the oils.  

One of the very best penetrating oils is Oil of Wintergreen applied to a warm joint and allowed to soak for at least an hour. It is not used much anymore as it is now considered too toxic. It was available sufficient quantities in a lot of over the counter ligaments to do the job until they cut down on concentrations.  This is why some of the better penetrating oils disappeared.


   

metengr (Materials) 8 May 10 15:48
Best explanation I have seen is that it acts as a low viscosity lubricant; 字串5

http://en.wikipedia.org/wiki/Penetrating_oil
 

HDS (Mechanical) 10 May 10 12:12
PB B'laster says it is a catalyst. It does work but I don't know what is happening chemically.  

(Click:
Previous:SEM/EDS near Valparaiso, IN?   Next:Locking pump rotor to shafting
[Add TO Favorites] [TOP] [PRINT] [CLOCE WINDOWS]  
  Hot Article
·Material St 37-1 and St 37-2K
·1.0619 or 1.7365
·En equivalent AISI standard ma
·fatigue of 34 CrNiMo6
·Brinell to Rockwell C Hardness
·Help: Uddeholm 716 vs. Sandvik
·Weldox 700 Bearing Strength
·ST 52 / 34CrNiMo6 thruster sha
·ASTM A470
·4140 Cracking During Heat Trea
·Wohler /SN curve for 42CrMo4 s
·S-135 grade material required
  Related Articles
·Locking pump rotor to shafting
·Clear extruded flame retardant
·German terms in steel handling
·Bleed-Ring/Paddle Spacer
·17-4 PH
·Ultrasonic cleaning elasomers
·SA234 WPB
·British Standard for Materials
·Need analysis of tungsten carb
·Comparison between ASTM A284 D
·High Early Strength Concrete
·UNI material standard
MBT SHOES CLEARANCE SALE Cheap LouisVuitton Bags Civil / Environmental Engineers Structural Engineers Aeronautic Engineers Automotive Engineers Chemical Engineers Geotechnical Engineers Industrial / Manufacturing Engineers Materials Engineers Computer Engineers Agricultural Engineers Mechanical Engineers Petroleum Engineers Bioengineers Military Engineers